Zapišite vsebino pojavnega okna svoje trgovine
ONE VEST.
EVERY HUNT.
The modular hunting system built to adapt to you. DISCOVER THE INTEGRATOR
What’s in the box?
1. INTEGRATOR Vest | 2. Side panel (left)
3. Side panel (right) | 4. Cord stopper
5. Rubber cord (right) | 6. Rubber cord (left)
7. Plastic Hook | 8. Eye
9. T1 strap | 10. Pull Tab
11. Carabiner | 12. MOLLE webbing
13. MOLLE clip | 14. D-ring strap
15. Female Buckle | 16. Male Buckle
17. Back panel | 18. Cradle straps
19. Cradle | 20. Hook-and-loop Tape Opening Tool
21. MOLLE clip thread tool
Setting up the „T1” Quick Release Strap
Optional: Use the V1 Quick
Release Strap for Guns with
a Scope.
Step 1: Make sure that the MOLLE clip at the tip of the T1 strap is thread through the 4th MOLLE webbing from below going upwards. Use the lower MOLLE clip for guns with a smaller barrel diameter.
Step 2: By pulling the T1 strap downwards a few times, verify that the MOLLE clip sits firmly on the webbing, and that both ends (horns) of it are anchored well, preventing the T1 from slipping out of the webbing.
Step 3: The MOLLE clip of the D-ring should be thread through the 2nd MOLLE webbing, also going upwards from below. Double check that it is anchored well the same way you did check the T1 in the previous step.
Feel free to use webbings other than the 4th and 2nd if it fits you better.
The Carabiner should be attached to the D-ring so that the Pull Tab is pointing downwards while the gate of the Carabiner is pointing upwards.
Use the MOLLE clip threading tool for easier threading through the webbing.
Step 4: Make sure the plastic Hook attaches to the right eye on the T1 - which is the one closer to the back.
Step 5: Push and hold the button on the cord stopper, move it all the way up, and pull the rubber cord backwards until the T1 is hanging backwards on your shoulder. Then release the button so that it stops and holds the cord in place tightly. This will ensure that the T1 „snaps back” the moment the Carabiner is released.
Holstering the Gun
Step 1: Loop the T1 strap around the Barrel and attach the Carabiner securely to the D-ring.
Step 2: Verify that all parts of the T1 strap are attached securely.
Step 3: Tighten the rear straps to raise the Cradle and tilt the Barrel forward.
Loosen the rear straps to lower the Cradle and tilt the Barrel backwards (upwards).
Step 4: Tighten the front straps to raise the Cradle and tilt the Barrel backwards (upwards).
Loosen the front straps to lower the Cradle and tilt the Barrel forward.
Step 5: When attaching the Carabiner to the D-ring, make sure that the gate is pointing upwards and the Pull Tab is hanging downwards. If not, verify that the strap is looped correctly and flip/adjust if needed.
Slightly pulling on the Pull Tab helps to close the Carabiner more easily.
Releasing the Gun
In a right-handed setup:
Step 1: Grab and hold the stock with your right hand
Step 2: Sharply pull downwards and then release the Pull Tab with your left hand.
Once you pull, the Carabiner will open, and once you release, the rubber cord will snap the T1 strap back across your shoulder, essentially removing it from your way to allow a clear shouldering of the gun.
Warning
WARNING
Failure to follow the safety guidelines and instructions in this manual can
result in serious personal injury, death, and/or damage to property.
WARNING
Always ensure that your specific gun fits correctly and is securely held by
the INTEGRATOR holster before carrying it. Test the fit with the gun completely unloaded
— chamber and magazine empty. Do not carry a loaded gun in the INTEGRATOR until you
have personally confirmed a proper and secure fit.
WARNING
Before using your gun with the INTEGRATOR, read and follow the owner’s
manual provided by the firearm’s manufacturer. Ignoring the firearm manufacturer’s operating
instructions and safety warnings could cause an unintentional discharge, potentially
resulting in serious injury or death.
WARNING
Always keep your finger off the trigger and outside the trigger guard when
holstering or drawing your gun from the INTEGRATOR holster.
WARNING
Always engage all safety mechanisms on your gun before placing it in the
INTEGRATOR holster.
WARNING
Never cock your gun or operate any of its controls while it is in the INTEGRATOR
holster.
WARNING
Only carry guns that are in proper working condition and meet the manufacturer’s
specifications in your INTEGRATOR Rifle Holster System.
WARNING
Always know the condition of your gun (whether it is loaded or unloaded and
whether there is a cartridge in the chamber) before holstering it.
WARNING
Always make sure the gun is unloaded before engaging in vigorous activity
with your rifle or shotgun holstered, such as running, climbing, or jumping.
WARNING
Do not modify, alter, disassemble, or remove any part of the INTEGRATOR
Rifle Holster System except as directed in this manual.
WARNING
Ensure that the scope and any mounted accessories of the gun are secured
and clear of snag points when holstering.
WARNING
Do not store the INTEGRATOR Rifle Holster System in places where it may
be exposed to excessive heat.
WARNING
The INTEGRATOR vest does not provide ballistic protection.
WARNING
Keep the INTEGRATOR and its add-ons out of reach of children
WARNING
Never point the gun at anyone while the gun is holstered in the INTEGRATOR.
Ammo Pouch
- 1.6 L volume (97 cu in)
- top opening „auto closes”
when flipped, prevents losing
shells
- available in 4 colors: orange,
coyote, green, brown
Tripod Holster
- Allows hands-free carrying of a tripod (bipod, or similar lengthy
accessory)
- Opens instantly with a single push of a button, lets you deploy
tripod one-handed
GPS Holster
- Fits Garmin® Astro®, Alpha®,
Dakota®, eTrex®, GPSMAP®,
inReach®, Oregon® and Rino®
series GPS handheld devices*
- Flips open in 90° for hands-free
viewing
Communication Device Holder – Združljiv z Integrator Modular Outdoor Vest
€42,00
Unit price perCommunication Device Holder – Združljiv z Integrator Modular Outdoor Vest
€42,00
Unit price perRadio Holster
- Fits most small handheld
radios and walkie-talkies
- Attaches to various MOLLE
webbings near the ear for easy
hands-free communication
Game Pouch
- Designed to carry small game:
turkey, pheasant, rabbit
- 12L volume
- Attaches to the back of the
INTEGRATOR for an ergonomic load
distribution
Backpack
- Can be attached to 5 different positions
on the chest, back and side
- Can hold a hand gun with an optional
removable Flexible Strap insert
- Opens in an instant with an emergency
pull tab (eg. to access a handgun)